-53-
Enable Bandwidth
Control all the time:
Select this option to enable Bandwidth Control all the time.
Enable Bandwidth
Control When:
With this option selected, the Bandwidth Control will take effect when the
bandwidth usage reaches the specified value.
Default Limit
Limited
Bandwidth:
Default Limit applies only for users that are not constrained by Bandwidth
Control Rules. These users share certain bandwidth with upper limit
configured here. Value 0 means all the remained bandwidth is available to
use.
splays the current enabled WAN port(s). The Total bandwidth is equal to
the sum of bandwidth of the enabled WAN ports.
Upstream
Bandwidth:
Displays
Upstream
Downstream
Bandwidth:
Displays
Downstre
n
WAN
page.
Interface Bandwidth
Interface:
Di
the bandwidth of each WAN port for transmitting data. The
Bandwidth of WAN port can be configured on
WAN
page.
the bandwidth of each WAN port for receiving data. The
am Bandwidth of WAN port can be configured o
Note:
●
T
eam/Downstream Band
he Upstr
width of WAN port you set must not be more than the bandwidth
provided by ISP. Otherwise the Traffic Control will be invalid.
●
If there are data flowing into the router from interface A and out from interface B while the
downstream bandwidth of A is dif
he smaller one
ferent from the upstream bandwidth of B, then t
should be considered as the effective bandwidth, and vice versa.
●
Click the <View IP Traffic Statistics> button to jump to IP Traffic Statistics page.
3.3.2.2
On th
the Ba
Choos
u
Advanced
→
Traffic Control
→
Bandwidth Control
to load the following page.
Bandwidth Control
is page, you can configure
e the men
ndwidth Control function.