-57-
Figure 3-38 Session List
In this table, you can view the session limit information of users configured with Session Limit. Click
the <Refresh>
button to get the latest information.
3.3.4 Load Balance
In this part, you can configure the traffic sharing mode of the WAN ports to optimize the resource
utilization.
3.3.4.1
Configuration
onfiguration
to load the following page.
Choose the menu
Advanced
→
Load Balance
→
C
Figure 3-39 Configuration
With
re
Enable
source IP address and destin
ss of the packets as a whole and record the WAN port they
pass through. And then the packets with the same source IP address and destination IP address or
destination port will be forwarded to
multi-connected applications
Check the box before
Enable Bandwidth Based Balance Routing
and select the WAN port below,
Load Balance of the specified WAN port will be enabled automatically if no routing rules are set.
Then click th
tton to apply
the box befo
Application Optimized Routing
checked, the router will consider the
ation IP addre
the recorded WAN port. This feature is to ensure the
to work properly.
e <Save> bu
.
Note:
The W
ectin
AN ports not conn
g to the Internet don’t support Intelligent Balance, please do not select
them.
3.3.4.2
Policy Routing
Policy Routing provides an
the policy defined by the
netwo
.
Choos
nced
e following page.
accurate way to control the routing based on
rk administrator
e the menu
Adva
→
Load Balance
→
Policy Routing
to load th