-60-
N
AN button
y in the primary
WAN Config:
The WAN port in the secondary WAN list will share the traffic for the
WAN in the primary WAN list under the specified condition.
Mode:
You can select Timing or Failover Mode.
Timing:
Link Backup will be enabled if the specified effective time is reached. All
the traffic on the primary WAN will switch to the backup WAN at the
beginning of the effective time; the traffic on the backup WAN will switch
to the primary WAN at the ending of the effective time.
Failover:
Specify the premise for Failover Mode. The backup WAN port will be
enabled
is met.
Time:
effective time if Timing Mode has been selected.
Then the backup WAN port will be enabled, while the primary WAN port
e time is from the start
time of the day to the end time of the next day.
Status
:
Activate or inactivate the entry.
List of Rules
You can view the information of the entries and edit them by the Action buttons.
The first entry in Figure 3-41 indicates: WAN1 is the primary port and WAN2 is the backup port.
General
WAN Ports:
Displays all the WAN ports in use. You can drag the light-blue WAN
button to primary and backup WA list. The color of W
changing to gray indicates that the WAN port is alread
and backup WAN list.
only when the premise
Backup Effective
Specify the backup
is disabled in the specified time period. When the start time you enter is
not earlier than the end time, the default effectiv
WAN2 will be enabled while WAN1 is failed. This entry is enabled.
Note:
The same WAN port cannot be added to the primary and secondary WAN lists at the same time, and
one WAN port should be added to only one list.