TD-W8901G
54M Wireless ADSL2+ Router User Guide
41
4.5.2.2 MAC Filter
Select
IP/Mac Filter
as the Filter type, and select
MAC
as the Rule type (shown in Figure 4-33),
and then you can configure the filter rules based on MAC address.
Figure 4-33
¾
Rule Type:
Select MAC for the MAC Filter rule.
¾
Active:
Select “Yes” to make the rule to take effect.
¾
MAC Address:
Enter the MAC address for the rule.
¾
Rule Unmatched:
If the current rule can not match, and you select
Forward
, the router will
skip the rule and transmit directly.
If you select
Next
, the router will find the next filter rule
(show in Filter list) to match.
¾
IP/MAC Filter Listing:
This displays the information about the MAC Filter rules.
To add a MAC Address filtering entry:
For example:
If you want to block the PCs with MAC addresses 00-0A-EB-00-07-BE and
00-0A-EB-00-07-5F to access the Internet, you can configure as follows. Presume the rules are
both aimed at the interface PVC0, and their indexes are (1, 1) and (1, 2).
Step 1:
Select the “IP/MAC Filter” as the Filer Type Selection:
