TD-W9980B
N600 Wireless Dual Band Gigabit VDSL2 Modem Router (Annex B) User Guide
When you want to add or modify an IP & MAC Binding entry, you can click the
Add New
button or
Edit
button, and then you will go to the next page. This page is used for adding or modifying an IP
& MAC Binding entry (shown in Figure 4-103.)
Figure 4-103
To add IP & MAC Binding entries, follow the steps below.
1. Click the
Add New
button as shown in Figure 4-102.
2. Enter the MAC Address and IP Address.
3. Select the Bind checkbox.
4. Click the
Save
button to save it.
To modify or delete an existing entry, follow the steps below.
1. Find the desired entry in the table.
2. Click
Edit
as desired on the
Edit
column.
Click the
Enable/ Disable Selected
button to make selected entries enabled or disabled.
Click the
Delete Selected
button to delete selected entries.
4.19.2 ARP List
To manage the computer, you could observe the computers in the LAN by checking the
relationship of MAC address and IP address on the ARP list, and you could also configure the
items on the ARP list. This page displays the ARP List; it shows all the existing IP & MAC Binding
entries (shown in Figure 4-104).
Figure 4-104
MAC Address:
The MAC address of the controlled computer in the LAN.
IP Address:
The assigned IP address of the controlled computer in the LAN.
Status:
Indicates whether or not the MAC and IP addresses are bound.
Load:
Load the item to the IP & MAC Binding list.
98
