Quick Start Guide
*Images may differ from actual products.
VIGI C330I is used for demonstration in this guide.
Appearance
*Some models do not have the power supply interface. You can check the
detailed specifications on the product page at https://www.tp-link.com/.
Power Supply Interface (12V DC)*
4
RJ45 Ethernet Port (supports PoE)
3
IR LED
2
Lens
1
2
3
Package Contents
Network Camera
Waterproof Cable
Attachments
Quick Start Guide
Anchors and Screws
Quick
Start
Guide
•
Make sure your power supply matches your camera.
The camera’s standard power supply is 12V DC* or
PoE (802.3af/at). The power source should meet LPS,
PS2, and other requirements according to IEC
62368-1.
•
Make sure that the wall is strong enough to
withstand 4 times the weight of the camera and
mounting bracket.
• If you are uncertain or uncomfortable performing the
installation, consult a qualified electrician.
Safety First:
Installing Waterproof Cable Attachments
Install the waterproof cable attachments for the network
interface when the camera is installed outdoors.
Note: Make sure each part is securely attached and the waterproof
rings are flush to keep out water.
Done!
The network interface is now waterproof.
1
Mount Camera
Fix Nut
Waterproof
Ring
O-ring
Network
Interface
Waterproof
Jacket
1. Route the network cable through the following
components in order: fix nut, waterproof ring, and then
the waterproof jacket.
2. Fix the O-ring to the network interface of the camera and
connect the network cables.
3. Attach the network interface with the waterproof jacket,
then twist to lock.
4. Insert the waterproof ring into the waterproof jacket.
Rotate the fix nut to secure it to the waterproof jacket.
2
Mounting Template
1
Option 1: Wall/Ceiling Mounting
1. Stick the mounting template to the desired mounting place.
Drill 4 screw holes according to the template.
2. Insert the anchors into the holes, use the provided screws to
fix the camera’s bracket to the wall or ceiling.
Option 2: Pole Mounting
1. Thread each of the two cable ties through the slits on the
back of the camera’s bracket indicated below.
2. Slip the two cable ties through the pole. Tighten them to
firmly attach the pole.
OR
4
