F. MAINTENANCE
1.
Battery Replacement:
The meter will display AT when
the 9 volt battery needs replacement. Battery replaced as
following:
a. Disconnect and remove all test leads from live circuit
and from the meter.
b. Remove the meter from protective boot.
c. Remove the three screws from battery cover of back
d. Remove old batteries and replace with new batteries.
e. Reassemble instrument in reverse order from above.
2.
Fuse Replacement:
Both the A and mA/uA input jacks
are fuse protected. Use only Fast blow, 600V fuses with
correct current ratings. Failure to do so will void all
Warranties. If either do not function, replace as Following:
a. Disconnect and remove all test leads from live circuit
and from the meter.
b. Remove the meter from protective boot.
c. Remove the three screws from battery cover of back
d. Remove old fuse(s) and replace it with new fuse(s).
e. Reassemble instrument in reverse order from above.
f. Fuse must be changed by replacement in service center.
3.
Cleaning your Meter
Use a mild detergent and a slightly damp cloth to clean the
surfaces of the meter.
36
E. ACCESSORIES
35
Standard Accessories
Part NO.
9 Volt Alkaline Battery
Fuse 0.5A
Fuse 0.44A(Only194)
Fuse 10A
Fuse 11A(Only194)
Test lead
Rubber boot
Optional Accessories
Accessories
Part NO.
Demonstration Software
Deluxe Test lead set
IEC 1010 Deluxe test lead kit
Temperature Adaptor
A301
Current Adaptor 10/60A
A254
Current Adaptor 40/400A
A256
Current Adaptor 400/1000A
A296
Carrying case
