Section 2 – Installation
11
2.7
Setting the Pump Speed to 50%
Operators who wish to use the
easy
FLOW-VS
at a low speed may find it difficult to set the desired
speed accurately with the
Dose Rate
control. A “50%” jumper fitting is provided for these users. To
select “50%” speed operation…
1. Remove the front panel and locate the jumper settings, as per the instructions in section 2.6.
2. Set jumper J3 to
On
to select 50% speed operation.
3. If the unit is returned to the factory default
Off
setting at a later time, we recommend that you
fit it to one of the pins. This way, it will not be lost if the jumper is to be replaced at a later time.
