![background image](http://html1.mh-extra.com/html/tq/ilm-series/ilm-series_assembly-instructions-manual_1146539022.webp)
Assembly Instructions | ILM Servo Kits
22
Edition 03/2021 EN
Assembly
7.3 Bonding instructions
WARNING
Danger of eye injury and skin irritation by adhesives
The adhesives used for bonding can cause severe eye injuries and skin irritations.
►
Wear safety goggles to protect your eyes and wear safety gloves until you have fin-
ished installing the ILM servo kit.
►
Read and follow the safety data sheets provided with the adhesive.
7.3.1 Stator
1
2
Fig. 12: Bonding the stator in position
►
Assemble the bonding kit for the TQ-Drives stator.
►
Clean and degrease the bonding surfaces (see Fig. 11 on page 21) following the
adhesive manufacturer’s instructions.
►
Apply a bead of adhesive (e.g. LOCTITE 9497) all around the edge (item 1 in Fig. 12)
inside the housing.
►
Push the stator into the housing as far as it will go. The adhesive is distributed by the
stator.
►
Remove any excess adhesive.