| 10
4.2
Memory - batches
The memory of the CurveX 4 can store a total of
1.000.000 readings. The memory is divided into 20
memory blocks of 50.000 readings each.
For each new batch, the CurveX 4 will always start
at the beginning of the next memory block, even
if the previous block was only partly used. loggings
that take longer than 50.000 readings are stopped at
reading number 50.000. The maximum number of
batches that can be stored is 20.
4.3
CurveX 4 tasks
This table below describes the most frequently
performed tasks:
Task
Action on logger
Ideal Finish
Option
software menu
Power on
Press POWER button
START
logging
Press START button
STOP logging
Press STOP button
Power off
Press POWER button
Download data
Logger
Download all data to PC
Change settings
Logger
user settings
4.4. Downloading Data And Configuring
The CurveX 4
The CurveX 4 is a logger without a display. You will
have to use Ideal Finish Analysis to download data
and change the settings of the logger. The license
key and memory stick with the Ideal Finish Analysis
software are part of the CurveX 4 package. For the
installation of the software you are referred to the
software manual. To obtain your CurveX 4 license
key you are referred to the Ideal Finish Analysis Quick
Start Manual.
After the installation of the software you can con-
nect the logger to your computer and access the
logger menu where the following options are avail-
able. For information about installing the software
and connecting the logger you are referred to the
software manual.
Step 1.
Power on the data logger by pressing the
POWER button (see figure 1, position 1) and
start the Ideal Finish Analysis software.
Step 2.
Connect the USB connector to the CurveX 4
(see figure 1, position 8).
Step 3.
Connect the other side of the USB cable to
the PC.
Step 4.
Choose logger from the menu.
The following options are available:
•
Download all data to PC
•
Download Express
•
Real
Time…
•
User settings
•
Configure & test