Parameterization and Configuration
TR-Electronic GmbH 2018, All Rights Reserved
Printed in the Federal Republic of Germany
Page 154 of 167
TR - ELA - BA - DGB - 0027 - 03
11/12/2019
6.4.2.2 Input data
6.4.2.2.1 Status
Error messages
Byte
X+0
X+1
Bit
15 – 8
7 – 0
Data
2
15
– 2
8
2
7
– 2
0
Bit
Description
2
0
…2
14
reserved
2
15
Position error
The bit is set if a magnet is outside the measuring range, the magnet minimum distance
is not achieved or if the number of configured magnets does not match the number of
operated magnets. No valid position signal can be generated. The bit is automatically
reset when the error has been rectified.
Warning messages
Byte
X+2
X+3
Bit
15 – 8
7 – 0
Data
2
15
– 2
8
2
7
– 2
0
Bit
Description
2
0
Magnet outside measuring range
The bit is set when a magnet is located outside the measuring range. However, a valid
position signal can still be generated. The bit is automatically reset when the error has
been rectified.
2
1
Adjustment value is set
The bit is set when the function "Set adjustment value" has been triggered by the control
byte in the output data. The bit is automatically reset when the process is complete.
2
2
Configuration error
The bit is set if the number of configured magnets does not match the number of
operated magnets. The bit is automatically reset when a match has been determined.
2
3
…2
15
reserved
