as a cut at mid frequencies. Its sound is ideal for both finger picking and strumming styles of
playing and adds a ‘Sparkle” to the amplified sound.
Chorus
The chorus is switched into circuit with the PULL switch on the chorus DEPTH control. There is
also a foot switch socket on the rear of the unit for switching the chorus in and out, however the
front panel switch must already be ‘on’ for this footswitch facility to function.
The CHORUS section has controls for the DEPTH and the SPEED of the effect and when switched
into the circuit it effects both channels equally.
Reverb
A spring REVERB is provided and is switched into the circuit with the PULL switch on the reverb
LEVEL control. There is also a foot switch socket on the rear of the unit for switching the reverb in
and out, however the front front panel switch must already be ‘on’ for this footswitch facility to
function.
On the TA40R the reverb has controls for level and tone. On the other models only a level control
is available.
Mains inlet socket
The MAINS INLET SOCKET is placed on the rear panel. Above this the required mains voltage will
be clearly marked. Make sure this is correct for your country prior to connecting the supply to the
unit.
BACK PANEL CONTROLS
MANUFACTURED IN ENGLAND BY:- TRACE ELLIOT LIMITED
MAINS INPUT 65VA
EARTH LIFT
MODEL:-
OUTPUT POWER
35 WATTS RMS
70 WATTS PEAK
THIS APPARATUS MUST BE EARTHED.
FOR CONTINUED PROTECTION
AGAINST RISK OF FIRE REPLACE
ONLY WITH SAME TYPE AND
RATING OF FUSE
WARNING
TO REDUCE THE RISK OF FIRE OR
ELECTRICAL SHOCK DO NOT
EXPOSE THIS EQUIPMENT TO RAIN
OR MOISTURE. DO NOT OPEN -
NO USER SERVICABLE PARTS INSIDE
- DANGER OF ELECTRICAL SHOCK -
REFER TO QUALIFIED ENGINEER
FOR SERVICE.
WARNING
50/60Hz
V A.C.
MAINS FUSE
230v-
T500mA
115v-T1A
SERIAL No:-
POWER ON
OFF
LINK/D.I.
FOOTSWITCH
RING = CHORUS
TIP = REVERB
8
