when the second digits are within 00-29 second range. Press
"S" button to reset second digits to zero and minute digits
advance by 1 increment when second digit are within 30-59
second range.
5. When the time setting for the clock is ready, press the clock
button once to return to normal clock display mode.
** When the timer is running, the corresponding indicator (T1,
T2, T3, T4) flashes on display. All four timers can run at the
same time. When the timer reaches to 0:00 00, the buzzer will
sound and the corresponding indicator (T1, T2, T3, T4) will
flash relatively slower. More than one indicator can flash at
the same time.
Count-Down Timer Setting
1. Press the T1, T2, T3, or T4 button enter to the desired timer
channel. In timer mode, the colon does not flash and the
corresponding timer indicator "T1", "T2", "T3", or "T4" shows
on the display.
2. Press the HOUR button to advance the hour digits.
3. Press the MINUTE button to advance the minutes digits.
4. Press the SECOND button to advance the seconds digits.
5. Press the HOUR, MINUTE, or SECOND button for 2 seconds
for fast setting of the corresponding digit.
6. Press the CLEAR button to clear the Count-Down Timer and
the corresponding timer memory to 00H00M00S
7. Press the HOUR and the CLEAR buttons simultaneously to
clear the hour digit setting only.
8. Press the MINUTE and the CLEAR buttons simultaneously to
clear the minute digit setting only.
9. Press the SECOND and the CLEAR buttons simultaneously
to clear the second digit setting only.
Count-Down Timer START/STOP
1. After time setting is ready, press the START/STOP button
once. The timer will start to countdown at 1 second resolution.
2. Press the START/STOP button once to stop the counting
timer.
3. Press the START/STOP button once again, the timer will
resume counting
Count-Down Timer Alarm
1. When the timer counts down to 0:00 00 in its timer mode, the
buzzer will sound.
www.
.com
information@itm.com
1.800.561.8187
