www.tracer.eu
11
ABNORMITY AND COUNTERMEASURE IN USE
Nr
Nieprawid
ł
owo
ś
ci
Przyczyna
Ś
rodki zaradcze
1
After
fi
nishing the
normal shredding, it runs
ceaselessly yet.
Too much scrapped
paper in the
wastebasket, so that
the just scrapped paper
cannot fall and leave in
the entry.
1. Cut off the power, and
empty the wastebasket.
2. Cut off the power, and
press the scrapped
paper down to make
them away from the
machine head.
2
Paper feed or positive
rotation is normal, but
there are still some
scrapped paper hanging at
the exit after
fi
nishing.
The slots of the blades
clamp the scrapped
paper.
Set the slide switch to
“REV” (if need, please
clean the scrapped paper
at the exit).
3
It can’t work if feeding
paper follows withdrawing
paper.
Some scrapped paper
lock automatic inductive
device.
Set the slide switch to
“REV”.
4
Some paper is in the
entry, but shredder does
not work.
After feeding paper, any
corner of the paper is
inserted, but the rest
doesn’t touch automatic
inductive device.
Adapt to the position of the
feeding paper and make
it touch the automatic
inductive device.
5
The paper is jammed,
and the machine stops
rotating.
1. The number of
the inserted paper
is larger than the
limitation
2. Locked rotor
makes the motor
overheated and
then temperature
protection set takes
action.
1. Set the slide switch to
“REV” and withdraw the
shredding paper.
2. Unplug the plug and let
the machine stop for a
while.
6
The machine doesn’t start
after inserting a sheet of
paper, or stop running
when paper is being
inserted.
The paper is too thin,
too soft, humid, or
too crinkly to activate
automatic inductive
device.
1. Fold the paper and then
insert it.
2. Set the slide switch to
“REV”.
Paper Shredder Tracer Exclusive Scirocco
