Instructions
for use
21
5. Assembly of the arm support: Insert the
aluminum stem on the arm support into
the stem at the end of the main box and
tighten the fixing screw properly.
BATTERIES
Caution:
• This metal detector is powered by two
9-Volt alkaline batteries (not supplied).
• Only fresh and proper type of alkaline
batteries is recommended
• Do not mix the old and new batteries or
different types of batteries..
Installation
1. Be sure the power switch is at off-po
-
sition.
2. Slide the battery cover off in the direc
-
tion of the arrow.
3. Take out two battery connectors from
the compartment
4. Join the battery polarities with the con
-
nectors.
5. Re-install the battery cover.
Warning:
Dispose of old batteries promptly and
properly, do not bury or burn the batteries.
Note:
• If you don’t plan to use the unit for a
week or more time, remove the batter
-
ies. Batteries can leak chemicals that
can destroy electronic parts.
• To extend the battery lift, exchange the
left and right battery after 3-4hours of
operation.
• „LOW BATT” icon will display on bottom
right corner of the LCD when the batter
-
ies are needed to be changed..
CONTROL PANEL
LCD Indicators:
Operating Mode Indicator
: shows cur
-
rent operating mode, among the 4 oper
-
ating modes the detector has: DISC, ALL
METAL, NOTCH, AUTO-NOTCH.
Status Indicator:
shows current sta
-
tus (SENS adjustment, DISC range ad
-
justment or NOTCH range adjustment),
SURF-ELIM selected or not, and low-bat
-
tery or not.
DISC/NOTCH range
operating
mode
status indicator
dept
indicator
SENS
indicator
target indicator
