4.6 Road Mode
When it is necessary to operate the machine on public roads, you
must utilize the machine in road mode (see notes below).
To implement road mode:
1.
Install the clear plastic side shields (windows) with included
hardware onto the sides of the cab enclosure from the inside.
2.
Raise the lift arms upward approximately 1/3 of possible travel.
3.
Have an assistant install the lift arm supports over and onto the
cylinder rods and secure with pins, then stand clear.
4.
Lower the lift arms (gently) until they rest on the supports.
5.
Curl the bucket fully and have an assistant install the
quick attach locking mechanism to immobilize it for on road
travel.
6.
Install the cutting edge guard onto the bucket and secure.
7.
Press the “road mode” switch (item 4) on the dash panel to
disable unnecessary items and enable road mode only controls
for on road operation.
8.
Utilize the drive control to direct machine movement and any
relevant road mode controls (items 1-3) to operate the machine
in accordance with local regulations and mandates. (fig. 4.6-1)
9.
To disengage road mode, reverse steps 1-7 of this procedure.
Note:
Steps 1, 5 apply only to machines sold and operated in Italy.
Note:
Road mode is not intended for performing work, do not carry
loads while operating in road mode. Lift arm and bucket functions
are disabled whenever road mode is engaged, curl bucket to upper
limit prior to engaging road mode.
43
4 MACHINE DESCRIPTION / CONTROLS
1
4
3
2
4.6-1
Summary of Contents for Terex PT30CE
