5.8 Loading
Steps: (see illustration)
1.
Raise the lift arms upward, carefully maintaining the bucket
angle, until the bottom of the bucket clears the side of the truck
bed or trailer.
2.
Once clear, drive the machine forward until the pivot point of the
bucket clears the bed side.
3.
Tilt the bucket forward until all of the material has been
released into the bed.
Note:
It may be necessary to quickly tilt and curl the bucket while
releasing material into the truck bed to evenly distribute the material
within the bed.
5.9 Fastening Attachments
1.
Make sure the locking levers on the quick attach mechanism
are in their respective unlocked positions. (fig. 5.9-1)
2.
Drive the machine to the attachment and hook the top edge of
the quick attach under the upper lip of the attachment.
3.
Curl the quick attach slowly upward by moving the lift arm con
trol joystick to the left until the attachment is properly mated
with the quick attach mechanism. (Curl enough to lift the
attachment off of the ground.)
4.
Once the attachment is properly mated, move the two locking
levers inward and downward to lock the attachment in place.
Note:
When fastening an attachment, always visually verify that the
attachment is locked in place prior to operation. (fig. 5.9-2 & 5.9-3)
5 OPERATION
51
Summary of Contents for Terex PT30CE
