7.5 Engine Oil Check
1.
Park the machine on level
ground, lower the lift arms,
stop the engine and remove
the key.
2.
Open the hood to gain access
to the engine compartment.
3.
Locate and remove the
engine oil dipstick (1) from its
tube. (fig. 7.5-1)
4.
Wipe the dipstick with a clean
shop cloth and reinsert it into
the tube until it comes to rest
in its seated position.
5.
Remove the dipstick once
again and inspect the end for
oil on the level indicator.
6.
Oil should be present on the dipstick up to, but not over the
upper (full) level indicator notch. If the level is correct, reinstall
the dipstick and then close and latch the hood to complete the
procedure. (fig. 7.5-2)
7.
If the level is low, add the proper grade and viscosity engine oil
and re-check as necessary until the proper level has been
achieved. Then re-install the dipstick and filler cap and close
and latch the hood to complete the procedure.
7 MAINTENANCE
66
Full
Low
1
7.5-1
7.5-2
Summary of Contents for Terex PT30CE
