The 2.4GHz radio band has a completely different behavior than
previously used lower frequency bands. Keep always your
model in sight as a large object can block the RF signal and lead
to loss of control. The 2.4GHz RF signal propagates in straight
lines and cannot get around objects on its path. Never grip the
transmitter antenna when operating a model as it degrades
significantly the RF signal quality and strength and may cause
loss of control and danger.
Always turn on the transmitter first then the receiver. When
turning off the system, always turn off the receiver first then the
transmitter. This is to avoid having the receiver on itself as it
may pick a wrong signal and lead to erratic servo movements.
This is particularly important for electric powered models as it
may unexpectedly turn on the motor and lead to injuries or
death.
The shutdown sequence must be to first disconnect the receiver
battery then to switch off the transmitter. If the transmitter is switched
off while the receiver is still powered, it may lead to uncontrolled
movement or engine start and may cause an accident.
In particular, the 2.4G R/C FHSS system will affect the plane or the car
nearby after you turn on the transmitter.
Be sure to set the Fail Safe function on working situation, after finish
F/S every time, please following turn off the transmitter, Don't turn on
the transmitter halfway.
Do not operate outdoors on rainy days, run through puddles of water
or use when visibility is limited. Should any type of moisture (water or
snow) enter any component of the system, erratic operation and loss
of control may occur.
Do not use it in the night or a lighting storm as the bad weather will
make the radio controller ( R/C ) out of control.
Do not operate in the following places.
-Near other sites where other radio control activity may occur.
-Near people or roads. On any pond when passenger boats are present.
-Near high tension power lines or communication broadcasting antennas.
Interference could cause loss of control. Improper installation of your Radio
Control System in your model could result in serious injury.
Do not operate this R/C system when you are tired, not feeling well or
under the influence of alcohol or drugs. Your judgment is impaired and
could result in a dangerous situation that may cause serious injury to
yourself as well as others.
Do not touch the engine, motor, speed control or any part of the model
that will generate heat while the model is operating or immediately after
its use. These parts may be very hot and can cause serious empyrosis.
Always perform a operating range check prior to using.
Problems with the radio control system as well as improper installation in a
model could cause loss of control.(Simple range test method) Have a friend
hold the model, or clamp it down or place it where the wheels or prop
cannot come in contact with any object. Walk away and check to see if the
servos follow the movement of the controls on the transmitter. Should you
notice any abnormal operation, and do not operate the model. Also check
to be sure the model memory matches the model in use.
Before turn on the power:
Always checking the throttle trigger on the transmitter at the neutral position
and TH trim too. When making adjustments to the model, do so with the
engine not running or the motor disconnected. You may unexpectedly lose
control and create a dangerous situation.
3
2
Summary of Contents for TS3T
Page 1: ...INSTRUCTION MANUAL ...
