14
NOTE:
KNS provides the remote access PC-software (SCS) for the antenna monitoring
and setting on your PC. (See Appendix C - Software downloading)
3.2.4 Satellite Researching
When antenna takes too long or fails to locate the target satellite by having blockage or
tough sea condition etc., you may use this function. Pressing “SEARCH/↓” button for 2
sec will automatically initiate the satellite researching function.
3.2.5 Checking System Error
Press MENU button will shows system error message code in hexadecimal digit on the
main LDC display. (Refer to Appendix D - Error Code)
Figure 24 - System Error Code
3.2.6 Checking System Communication Status
User may check communication status between ACU and PCU.
Figure 25 – Checking Communication Status
In the Figure - 25, Packet is the number of command from ACU and Loss is the number
of loss on the PCU. More loss means having more system communication error
3.3 Set-up Mode
To enter the set-up mode, press “MENU” button for 2 sec and use “↑,↓” key to change menu
and press “MENU” button to select. You may exit the set-up menu with using “ESC” button.
The set-up mode has 8 sub-menu. These are: 1) link with the PC, 2) Set latitude and longitude, 3)
program area, 4) program satellite, 5) satellite parameter edit, 6) skew angle setting, 7) satellite
name edit, and 8) save & exit.
The set-up menu flow chart shown below describes the searching and tracking set up procedures.
(see Figure- 26)
