CAMON TC07 Turf Cutter
TC07 Turf Cutter
Page 7
PLEASE NOTE THAT THIS IS A TWO STAGE LEVER. THE GREY BUTTON MUST BE
DEPRESSED BEFORE THE MAIN LEVER CAN BE PULLED UP.
This lever operates both the cutting blade and the driving power to the back
wheels. It does this by raising the engine speed until a centrifugal clutch engages
and transfers the engine power to the driven components of the TC07.
Letting go of the drive lever causes the engine revolutions to drop, the centrifugal
clutch to disengage and both the engine drive and cutting blade to stop moving.
5.6
Cutting Depth Adjustment
The cutting depth of the blade is adjusted using the two
adjuster knobs - the lower locking knob and the top
height adjustment knob. The top height adjustment knob
is connected to a length of threaded rod that is wound
into and out of the chassis. These knobs are located in
front of the handlebar mounting on the top section of
the main chassis.
The lower knob is for locking the position of the top knob. To adjust the depth of the
cutting blade, first loosen the lower locking knob. Once this knob is able to move
freely, you can adjust the position of the top knob into and out of the chassis by
turning it clockwise and anticlockwise.
Using the indicator sticker on the thread of the top knob it is possible to choose
your required depth of cut. This ranges from 25mm to 40mm.
5.7
Machine Lifting Lever
Located at the rear of
the machine, below the
handlebars, this lever allows
the operator to move the
cutting blade in and out of the
ground.
1
2
BLADE OUT OF GROUND
BLADE IN GROUND