CAMON TC07 Turf Cutter
TC07 Turf Cutter
Page 13
At the end of the strip of turf, raise the lifting lever to raise the blade out of the
ground.
Release the drive lever to stop the drive to the wheels and the blade.
Move the gear selector lever to the disengaged position ‘O’.
Operate the machine only in daylight or in good artificial light.
Always be sure of footing on slopes.
Do not work the Turf Cutter on slopes of more than 20 degrees and always work
across the slope, not up and down it.
Walk never run.
Never operate the machine with defective guards, or without safety devices, for
example deflectors and or catchers in place.
Do not change the engine governor settings or over speed the engine.
Disengage all levers, by releasing them, before starting the engine.
Start the engine carefully according to the instructions.
Do not tilt the machine when starting the engine.
Do not put hands or feet near or under the moving parts.
Never pick up or carry the machine whilst the engine is running.
Avoid operating the machine in bad weather conditions especially if there is the
risk of lightning.
6.5
Procedure for Unexpected Shut Down
Release the drive lever.
Turn the engine operating switch located on the handlebars to the OFF position.
Ensure the blade has stopped moving prior to moving the machine.
6.6
Residual Risks of the TC07 Turf Cutter
The TC07 Turf Cutter is designed to be pushed by the operator during transportation.
It has no brake system and the operator must hold firmly onto the machine at all
times when the machine is on sloped areas.
