SP8E Log Splitter
Page 14
SP8E/0612
Adjusting the beam
The CAMON SP8E has a telescopic beam which allows adjustment of the log pusher stroke at
three different lengths: 57, 67, 82 and 108 cm. To adjust the beam, proceed as follows:
([WUDFWWKHUHWDLQHUVSULQJZKLFKVHFXUHVWKHSLQORFDWHGXQGHUWKHEODGHSDJH¿JDDQG
10b).
([WUDFWWKHSLQIURPWKHRWKHUVLGH¿JD
Pull or push the beam until the locking holes for insertion of the pin coincide at the point desired.
)LWWKHSLQEDFNLQWRWKHKROHDQG¿[LWZLWKWKHVSULQJ¿JEPDNLQJVXUHWKDWWKHVSULQJLV
¿UPO\LQSODFH
WARNING: NEVER USE THE SPLITTER WITHOUT THE PIN INSERTED IN
THE BEAM, OR WITHOUT THE RETAINER SPRING IN THE PIN. BEFORE
STARTING WORK, MAKE SURE THAT THE SPRING IS FIRMLY IN PLACE
IN THE PIN.
Use of the Log Splitter
Do not use the machine outdoor when it is raining or snowing.
Make sure that the switch/cut-out of the general power system and the switch of the machine are
OFF.
Connect the electric log splitter to the power system inserting the plug in the socket beside the
electric motor.
Never pass the power cable over the working plane, close to the wedge or anywhere where it
may be damaged or severed.
Set the main on/off switch and then switch on the log splitter pressing the switch in the green
area.
The log pusher will move automatically to the fully open position.
3ODFHWKHORJRQWKHZRUNVXUIDFHQR¿JSDJH7KHVXSSRUWLQJJXLGHVKHOSWRNHHSWKH
log at the centre of the wedge. If the log tends to wobble, it must be repositioned turning it so
WKDWLVUHPDLQV¿UPO\RQWKHEHDP
Use
!
