Page
7
of
14
SETUP & OPERATION
UNPACKING
Carefully remove the TRACS unit from the box and separate it from all packing material.
Each unit is shipped with a carbon filter, HEPA filter and 2 UV lamps. The carbon filter
has a plastic cover and the lamps are in a box on top of the HEPA filter.
OPEN THE BACK-ACCESS PANEL
Remove the back-access panel by unscrewing the thumb screws near the bottom
counter-clockwise. Remove the entire panel and set it aside. The unit will not operate
while the lid is removed. The UV lights are very dangerous and you should never
defeat the interlock to energize the system with the cover removed.
INSTALL THE UV-C LAMPS
Two reflective UV shields located below the
prefilter basket cover the UV lamps in order to
increase UV intensity and to protect against
direct UV exposure to consumers.
Please wear protective gloves during the lamp
installation procedure as gloves will ensure oils
from your skin will not decrease the efficiency
of the lamps. Carefully remove each UV lamp
from the box and insert it into each lamp
socket firmly.
REMEMBER: these UV lamps have a 1 year
effective life span. They may remain
illuminated past 1 year but their efficiency
decreases over time. Please replace after 1
year for maximum efficiency of your TRACS portable UV-C air purifier.
