7
founder PRO
High Gear Servo state(High speed)
High Gear state
Low Gear state
Low Gear Servo state(Low speed)
Before you go on, here are some important precautions to keep in mind.
1.Allow the model to cool for a few minutes between runs. This is particularly important when using
high-capacity battery packs that allow extended periods of running. Monitoring temperatures will extend the
lives of the batteries and motor.
2. Do not continue to operate the model with low batteries or you could lose control of it. Indications of low
battery power include slow operation and sluggish servos (slow to return to center). Stop immediately at
the rst sign of weak batteries.
3.Do not drive the model at night, on public streets, or in large crowds of people.
4.Drive the Founder Pro primarily in low gear for maximum torque. High gear can be used for high-speed
running on open trails or when clearing steep slopes or gaps in rocks. Driving in high gear for extended
periods of time can result in the motor and/or ESC overheating and premature motor wear.
5.Because the model is controlled by radio, it is subject to radio interference from many sources beyond your
control. Since radio interference can cause momentary losses of control, allow a safety margin of space in
all directions around the model in order to prevent collisions.
6.Use good, common sense whenever you are driving your model. Intentionally driving in an abusive and
rough manner will only result in poor performance and broken parts. Take care of your model so that you
can enjoy it for a long time to come.
7.High-performance vehicles produce small vibrations that may loosen hardware over time. Frequently check
wheel nuts and other screws on your vehicle to ensure that all hardware remains properly tightened.
Operating the High-Low Transmission:
1.In the original state, use the third channel button of the remote control to switch the gearbox position.
There are obvious speed changes between the high-speed gear and the low-speed gear. The model
gearbox has a strong torque at low gears, which can extend the service
life of the motor. The corresponding gearbox lever and servo status are shown in the gure.
2.If you replace a new servo or transmitter, please adjust the servo parameters according to the state shown
in the gure. The main purpose is to adjust the EPA parameters of the corresponding channel of the
remote control to ensure the smooth operation of the servo in the working state. The servo will be damaged
due to long-term force.
Operating the Transfer Case:
1.The Founder Pro can switch three driving modes, namely 4WD, FWD and RWD, which are controlled by
the fourth channel of the transmitter, and the driving mode can be selected according to different road
conditions and vehicle states.
