5347-MAN-038-EN1-01 230VAC
4.5.
An extension cord should not be used unless
absolutely necessary. Use of an improper
extension cord could result in a risk of fire and
electric shock. If an extension cord must be
used, make sure:
a) That the pins on plugs of the extension cord
are the same number, size, and shape as those
of the plug on the charger;
b) That the extension cord is properly wired and
in good electrical condition;
c) That the wire size is large enough for the AC
ampere rating of charger as specified in the
following table
Recommended minimum AWG size for extension cords for battery support units
AC input rating Amperes
AWG size of cord
Length of cord, M
7.5
15
30
45
8-10
18
14
12
8
10-12
16
14
10
8
12-14
16
12
10
8
14-16
16
12
10
8
16-18
14
12
10
8
5.
Connecting to a vehicle
Please follow dealer standards guidelines for
connection methods.
Traction units are supplied with vehicle specific
adapters that should be used at all times.
Failure to use the adapters in the positions
prescribed could result in excessive heat being
generated in the lead set leading to premature
failure of leads and low voltage output.
Output leads are connected using the polarised
connectors on the unit and lead set.
The primary method for powering the support
unit is via the AC power cord.
6.
Warranty and Service.
For technical support call 866-628-5508 or email
oetech@service-solutions.com
.
For repair service, go to
repairtrack.bosch-automotive.com
or call 800-344-4013
7.
Manufacturer Information
Traction products are manufactured by:
Traction Chargers
Roundway Hill Business Centre
Devizes
Wiltshire
SN10 2LT UK
+44(0)330 022 7822
admin@tractioncharger.com
This symbol is used on products that contain a hazardous element and therefore
cannot be thrown away in the normal way. it appears on Electrical and Electronic
Equipment (EEE) as part of the WEEE (Waste EEE) directive – separate collection
facilities will be set up to divert WEEE away from landfill; funded by producers and
retailers of EEE
