MultiSat Control Panel Owner’s Manual
17
Chapter 2 - Installation
3.
Remove and save the standard maintenance port
assembly (see Figure 2-11).
Figure 2-11 Standard Maintenance Port Assembly
4.
Attach the MCP-ready maintenance port assembly to
the switchplate using two #4-24 screws (see
Figure 2-12). These screws simply replace the jack
screws you removed in Step 1.
Figure 2-12 MCP-Ready Maintenance Port Assembly
5.
Wire the TracVision antenna’s data cable to the
terminal board on the new maintenance port assembly.
Be sure to match the wire colors (body color/stripe color) with
the terminal board label.
6.
Using a P-clip, strain-relieve all wires at the switchplate
by securing them to the bottom screw of the
maintenance port assembly.
Standard
Maintenance Port Assembly
MCP-ready
Maintenance Port Assembly
YELLOW
Not Used
GREEN
Not Used
BRN/WHT
PC GND
WHT/BRN
PC TXD
ORG/WHT
PC RXD
WHT/ORG
RF GND
GRY/WHT
RF TXD
WHT/GRY
RF RXD
BLACK
Not Used
NOT USED
Not Used
Data Cable
to Antenna
Attach P-clip here
