8
ELECTRONIC OPERATING INSTRUCTIONS
Electronic controls will have either a round or oval keypad with the
TradeWind Logo Insignia printed on them. Please disregard these
instructions if this unit doesn't have this keypad.
DANGER:
KEEP HAIR AND CLOTHING A MINIMUM OF 12” AWAY FROM ALL SUCTION FIT-
TINGS AT ALL TIMES. PERSONS WITH LONG HAIR SHOULD EITHER SECURE THEIR HAIR TO A
MINIMUM LENGTH OR WEAR A BATHING CAP.
CHILDREN SHOULD NOT BE LEFT UNATTENDED AT ANY TIME IN THE UNIT.
WHIRLPOOL ONLY
1) To activate the whirlpool first fill the tub with water above the highest jet, and then press the ON button on
the round keypad.
2) To turn the whirlpool off press the OFF button on the round keypad.
THERMAL AIR
1) To activate the thermal air press the ON/OFF button once.
2) To increase/decrease the air volume coming from the air jets press and hold the middle button until the de-
sired volume is reached. The button will cycle between the increase mode and decrease mode every time the
button is released and then pressed again.
3) The system has two pulse cycles that are controlled by the right button. Press this button once for an increas-
ing/decreasing cycle, and twice for an on/off cycle.
4) To deactivate the Thermal Air press the ON/OFF button.
PURGE CYCLE
When the Thermal Air is turned off for the final time, the purge cycle is started. After twenty minutes the unit
will automatically turn itself on for one minute. The purpose of the purge cycle is to flush any residual water
out of the system. It is necessary for the unit to be drained prior to the purge for it to be effective.
Important Note:
Any time you put water into the unit and do not turn on the Thermal Air (i.e. take a shower,
clean the unit, or take a soaking bath) you must turn the unit on and then off as detailed above. This will start
the purge cycle to flush the system of residual water.
7612 Drag Strip Road – Fairview, TN 37062 – 615/799-8300 – www.tradewindinc.com