SECTION ONE: ASSEMBLY INSTRUCTIONS
MOUNTING LEGS AND WHEELS:
ch Leg, LEAVING NUTS LOOSE. Set
rill upright to level and then tighten all nuts.
OUNTING PELLET HOPPER/BURNER:
OT remove the white, square Burner Gasket (86) from the Hopper/Burner
(37).
1
)
Body (3)
until the Hopper/Burner (37) is snug against the end of the Grill Body (3).
) Align the bolt holes in the Grill Body (3) with the Nut Serts in the Hopper/Burner (37).
3)
rill
(37) Nut Serts.
Tighten all four Bolts –
DO NOT OVER TIGHTEN THE BOLTS.
PHILLIPS SCREWS
WITH FLAT WASHERS
AND HEX NUT
NOTE:
Install all Leg Screws and Nuts, 3 in ea
G
M
NOTE:
DO N
Slide the Hopper/Burner (37) square tube into the square opening located on the left
side of the Grill Body (3). Gently push the Hopper/Burner (37) into the Grill
2
Install a Flat Washer on each of the four Hex Head Bolts. From the inside of the G
Body (3) install these Bolts with Washers into the Hopper/Burner
LEG WITH HOLES FOR
XLE/WHEELS
N
YLOCK NUT
OUTSIDE
A
FLAT WASHER BETWEE
WHEEL AND LEG AND
BETWEEN WHEEL AND
N
LEG WITH
BOTTOM CAP
AXLE ROD
S INSIDE
(3 PER LEG)
