15
TRAEGER.COM
SUBSEQUENT START-UP
1
With the main power switch set to ON (
I
), press the center button
once to wake the grill controller. Set the desired temperature with the
“Up” button.
NOTE:
Once you press the IGNITE button, your Traeger® Fremont
Grill will always begin with an ignition and preheat cycle.
2
Once the desired temperature is displayed, press IGNITE. Allow grill to
preheat until desired temperature is achieved.
NOTE:
If the grill fails to achieve the selected temperature, please
see “Operating Tips” on page 24 for more information.
WARNING!
WHEN OPERATING THIS GRILL, MAINTAIN A
MINIMUM CLEARANCE OF 18 IN. (45.7 CM) FROM GRILL
TO COMBUSTIBLES.
CONTROL SHUTDOWN CYCLE
The control for this grill comes with an automatic shutdown
cycle. When finished cooking on your grill, press and hold the
center button for 3 seconds. The display will flash “OFF” for
several seconds, then scroll “COOL Dn” followed by the actual
temperature until the grill cools down enough to put out the fire
in the firepot.
While the controller is flashing “OFF,” you can cancel the
shutdown cycle by pressing and holding the center button
for two seconds.
Always allow the shutdown cycle to completely finish before
powering off your grill at the main power switch. The shutdown
cycle ensures the fire is suppressed and the grill ignites properly
on the next use.
DANGER!
TURNING OFF THE MAIN POWER SWITCH
WILL CUT POWER TO THE GRILL COMPONENTS ONLY.
WHEN SERVICING THE CONTROL OR ANY OTHER PARTS, ENSURE
THAT THE POWER SUPPLY IS DISCONNECTED TO AVOID AN
ELECTRICAL SHOCK HAZARD.
Summary of Contents for FREMONT
Page 6: ...6 6 ...
