User Manual
THIS DOCUMENT IS UNCONTROLLED WHEN PRINTED
Page
23
of
34
7.7.
Key pad access controller
The key pad is a suitable solution for longer term access control points at locations such as
worksites. Vehicles approaching the access control point enter a pin number that raises the boom.
STEP 1
–
Unpack the accessory and check components:
•
Check the condition of the accessory to ensure all components have been supplied.
STEP 2
–
Positioning the accessory:
•
Position the accessory in close proximity to the product.
•
Ensure the accessory is on a flat surface and secured to the ground to prevent it from falling.
•
Ensure the accessory is visible and accessible.
STEP 3
–
Test and operate the accessory:
•
The key pad is pre-programmed to work with the boom
•
The factory code is a 4 digit code which will be supplied with the accessory.
•
Test the key pad as a part of the operational testing sequence.
•
Enter the 4 digit code and wait for the boom to open.
STEP 4
–
Programming instructions.
•
Enter programming mode (one beep, green light flashes
once, red light “On” to confirm
you
are in programming mode):
o
* →
Master code → #
o
After 1min with no button pressed keypad will exit programming mode
•
Add a user in programming mode:
o
1 → user ID number → # → PIN → #
o
ID number can be between 1- 2000. The PIN is any 4 -8 digits with the exception of
1234 which is reserved.
o
Users can be added continuously without existing from programming mode as
follows:
▪
1 → User ID No → # → PIN → # → User ID No 2
▪
→ # → PIN → # Press # * to Exit.
•
Delete a user (orange light confirms you are in adding mode. Green light flash indicates a
user has been added):
o
2 → User ID number → #
o
Users can be deleted continuously without existing programming mode.
o
Press # * to Exit.
