Wiring the Solar Panel to the Sign
To wire the solar panel to the sign:
1.
Insert the connectors from the sign into the corresponding connectors from the solar panel as shown
below.
2.
Slide the connectors together until you hear a click and you can no longer slide them apart easily. Once
connected the cables should look like the following:
3.
Open the sign then close the fuses for the solar charger, as shown in the following image.
W
ARNING
:
It is vitally important, whenever you close the sign, that you close and lock
all
of the latches
properly to avoid water infiltration as this could damage the sign and void your warranty.
SafePace® 500 Installation Manual
p. 20