Watch this “Getting Started” video to learn the basics
https://trailkeg.com/pages/how-to
for instructional videos.
Your TrailKeg comes out of the box with the diptube
installed and a Perfect Pour restrictor attached. The
Perfect Pour restrictor slows down the flow rate of the
beer to help reach a balanced pour, while the keg is at
the proper storage pressure for the beer.
Pro Tip:
You can remove the Perfect Pour restrictor to
increase the flow rate by simply pulling it off the end of
the dip tube.
Visit your favorite local brewery and fill your TrailKeg
with fresh from the tap beer.
Before You Start
Pro Tip:
Request that the bartender use a fill tube
so there is less foam after the fill.
Pro Tip:
Install the TrailKeg lid, not the plastic lid
after filling. That way you don’t have to open the
growler again when you get to your destination.
The plastic lid is best for drinks like coffee or water
that are not carbonated.
Screw the lid onto the growler until it is tight.
Connect the tap to the ball lock post.
Pro Tip:
Transport your TrailKeg without the tap and
regulator connected.
Turn the regulator counterclockwise to the
OFF position. Screw a CO2 cartridge onto the
1
3
4
2
