Trailmaster BLE-PRO
Electronic Speed Controller for Brushed and Brushless Motors
___________________________________________________________________________________________________________________________________
TrailMaster BLE-PRO User Guide
pg 2
© 2015 Holmes Hobbies LLC / holmeshobbies.com
5.0 Stick Programming Mode
Plug a battery into the ESC and hold full throttle on the transmitter before the ESC arms, or
have a helper hold full throttle before you plug in the battery. After a few seconds you will
get the four rings in a row signaling full throttle calibration. Keep holding full throttle. After a
few more seconds, you will hear another four rings in a row. After the second group of four
rings, relax the throttle to neutral. If you have successfully entered programming mode, the
ESC will beep twice, pause, and repeat the two beeps.
The programming sequence is always presented in sequential order and always starts with
the first setting in the list in the following section. The first beep(s) signifies which section of
the programming you are in and the second beep(s) signifies which setting is waiting for a
“yes” or “no” answer
5.1 Stick Programming Steps
Full throttle = “yes”; Full Reverse = “no”
Question – Brake/Reverse Type
1.
With Reverse (default)
2.
Without Reverse
3.
Crawler Reverse
Question – Brake Amount
1.
25%
2.
50% (default)
3.
75%
4.
100%
Question – Reverse Amount
1.
25%
2.
50% (default)
3.
75%
4.
100%
Question – Punch/Traction Control
1.
High
2.
Medium
3.
Low
4.
Lowest
5.
Disabled (default)
Drag Brake
1.
Off (default)
2.
10%
3.
20%
4.
30%
5.
40%
Dead Band
1.
Large – 0.1500ms
2.
Normal – 0.1000ms (default)
3.
Small – 0.0750ms
4.
Very Small – 0.0500ms
5.
Smallest – 0.0250ms
Cutoff Voltage
1.
None
2.
Auto-LiPo (default)
3.
5v
4.
6v
5.
9v
6.
12v
Motor Timing
1.
Lowest
2.
Normal (default)
3.
Highest
Motor Type
1.
Brushless (default)
2.
Brushed Reversing
3.
Brushed High Power
6.0 Troubleshooting
ESC buzzes or at neutral
o
Turn off Holmes Hold, or turn down drag %
Drag brake or Throttle Damping doesn’t work properly
o
Recalibrate ESC to radio
o
Ensure that neutral setting on radio is adjusted properly
o
Reprogram ESC
No lights on ESC
o
Check that battery is plugged in, and polarized correctly
No power to motor
o
Ensure motor is plugged into ESC properly
o
Ensure motor is in good condition and brushes are properly operational
o
Ensure Battery is plugged into ESC properly
o
Ensure ESC is arming and plugged into RX properly
o
Ensure Battery is fully charged
ESC wont arm (all lights blinking)
o
Double check that radio is on, and that ESC is plugged into RX properly
o
Try adjusting neutral on your transmitter, or reversing your throttle
channel
If you have further troubles, contact us at Sales@HolmesHobbies.com or
Warranty@HolmesHobbies.com
