Airwolf 3D EVO22-T
Additive Manufacturing Center
Site Preparation Guide
F16467-58
4
Rev 10/12/2021
11.
Remove the tape that keeps the 3D Printer door closed, and open the printer door.
12.
Remove the two (2) zip ties around the two (2) chamber heaters inside the 3D Printer.
13.
Remove both the zip ties and the white clips that are attached to the left and right belts, which are located on the upper interior surface
of the 3D Printer (see image below):
NOTE
–
When removing the zip ties, be careful not to cut the left and/or right belts, as well as any internal cords within the 3D Printer.
Doing so will cause damage to the printer.
14.
Remove the clip attached to the Z Stage Ball screw by pulling on the zip tie that is attached to the clip.
