33
TRAK Machine Tools
Southwestern Industries, Inc.
ProtoTRAK SMX, K2, K3 & K4 & Retrofit Safety, Installation, Maintenance, Service and Parts List Manual
2.15 Lubrication
CAUTION!
Failure to properly lubricate the mill will result in the premature failure of bearings,
sliding surfaces & ballscrews
2.15.1 Manual Lubrication
The TRAK mill X & Y way surfaces and ball screws need to be manually lubricated. The Manual Lube automatically
discharges about 4ml of oil
every plunge.
1. At the beginning of each day, manually pull the pump handle.
Note: If the machine has been sitting for a long while, run the machine through the full length of its travel to
ensure lubrication reaches all surfaces.
2.
At the beginning of each day, check the oil level in the system. If low, fill with Mobil Vactra Oil No.
2 or equivalent.
CAUTION!
Failure to manually activate the pump at the beginning of each day and allowing the
pump to run dry may cause severe damage to the TRAK mill way surfaces and ball
screws.
Item Part Number Description
1
24000-1
SMX Pendant Assembly
2
24060-1
Enclosure Assembly, SX2
2
24060-2
Enclosure Assembly, SX3 and SX5
3
24999
Cable Breakout Box No Aux
3
24999-1
Cable Breakout Box With Aux
4
22555-10
Cable Assy - Logic
5
22555-10
Cable Assy - Logic
6
22556-10
Cable Assy - Parallel
7
22556-10
Cable Assy - Parallel
8
22608
Power Cord
9
20267
Cable Assy - AC to Computer
i01113
Part List-Cable Connection Diagram with Spindle Control
(Figure 16)
