8
TRAK Machine Tools
Southwestern Industries, Inc.
ProtoTRAK SMX, K2, K3 & K4 & Retrofit Safety, Installation, Maintenance, Service and Parts List Manual
2.2 Uncrating
Carefully remove the wood crate and protective packaging, paying attention not to scratch, damage, or mar any parts of
the machine.
Remove the cardboard boxes with the PENDANT DISPLAY (handle carefully) and the box
containing the TOOL BOX. The leveling pads and screws for the machine can be found in the toolbox. The Y way
covers are shipped in a separate tube.
Loosen and remove 4 screws and nuts holding the machine to the wood pallet.
ATTENTION!
Immediately report, in writing, any damages observed at this time that can be attributed to the
transportation or improper handling/moving of the machine.
2.3 Shortages: Inventory Checklist
_____ Machine (check model and serial number)
______ Manual drawbar with washer
______ Leveling pads (FC114), screws (FC112) and leveling nuts (FC113) (4 each)
______ Pendant Display with four 1/4-20 screws for mounting
______ Pendant Arm assembled to the column
______ Toolbox with various tools
______ ProtoTRAK SMX Safety, Operation & Programming Manual (P/N 24493)
______ TRAK K2, K3, K4 & Retrofit Safety, Installation, Maintenance, Service & Parts List
Manual (P/N 24319)
______ Way covers K2 – front of saddle - 20875
______ Way covers K3 & K4 – front of saddle - 20872
______ Way covers K2 – rear of saddle - 20874
______ Way covers K3 & K4 – rear of saddle - 20871
In case of shortages, contact the representative from whom you purchased the machine.
