4
Quick Start Guide
Quick Start Guide
2
T23 Fleet Basic Commands
This is a list of the most common commands that you will use.
For a full list see the T23_Fleet_User_Manual.pdf
located on your Tramigo CD.
Send ?, H or Help to see a list of the most common commands. Upper or lower case can be used in the com-
mands. Most commands also have a short form to save typing. For reports you can just use one letter to turn
the report on or off: Example sending an SMS with
A
will turn on alarm reporting if its currently turned off.
FIND
– Shows the location of your car. You can also
send a blank SMS message
FIND,NEAR
shows the 3 nearest locations
FIND,time
turns on periodic reporting. You will
receive a FIND report every x minutes specified
between 1 and 1440 minutes or daily or weekly
FIND,,distance
turns on periodic reporting. You will
receive a FIND report every x km specified between
0.5 and 1000
FIND,off
turns off periodic reporting.
F / F,NEAR / F,DAILY / F,WEEKLY / F,10 / F,,50 /
F,OFF
F,DAILY
will send a FIND report once per day
F,1,10,15
will send a FIND report every 1min or
10km (on trip mode) and when parked will send
FIND report every 15mins
Tramigo: Parked, 19595.7 km NW of Plaza
Monumental de Toros Tijuana, Tijuana, Baja Cali-
fornia, MX, old position, 20:38 Nov 5
Unit will show as parked until a trip has started.
The text
old position
means that the unit has not
had an updated position in over 3 minutes
LOCATION REPORTING
SMS Command
Example Command/Report
(Short form use)
TRIP,ON
– Sends a trip report when your car starts
a trip and after the car has been stopped for 15
minutes.
TRIP,NOW
– Will report a trip in progress or the last
Trip report if the unit is parked.
TRIP,OFF
– Turns off trip reporting
SET,TRIPSTART,0
– turns off trip start reporting
T,ON
T
With no parameters the command will toggle the
report off or on.
T,NOW
Will report the trip in progress or the last
trip report
T,OFF
Turns trip reporting off
Tramigo: trip report, start 0.19 km S of Hagalundintie, end 0.02 km N of Tramigo Office, trip time 0:27,
distance 1.61 km, max speed 33 km/h, avg speed 3.5 km/h, idle time 0:07, 11:44 Nov 6
ZONE,distance/on/off,placeName –
Will send a
report when the car entering or leaving an area
defined by a circle with a radius defined by the
distance from the place name. Distance can be 0.1
km to 999. You can use partial place names and the
system will select the closest one that matches
ZONE,OFF
- Turns off reporting
Z,1
Z,3,Home
Tramigo: Zone crossing detected, moving, 0.11 km
NE of Berjaya Times Square,Kuala Lumpur,KL,MY,
SW with speed 33 km/h, 09:25 Apr 19
ALARM,ON
– Reports when there is movement of
the unit or the vehicle moves 100m. Alarm Report-
ing is shut off after each report, the user must turn
the alarm on again to reactivate.
ALARM,OFF
– Turns off the monitor.
A,ON / A,OFF
Tramigo: Motion alarm detected, parked, 0.23 km
NE of West Coast Ferry Terminal, Clementi, SG,
17:07 Sep 15
SAFETY AND SECURITY REPORTING
1. Insert the SIM card.
You need a SIM card so you can communicate with your T23 Fleet.
Ensure that the SIM card is not protected by a PIN number
– this can be done by inserting the SIM into a
suitable mobile telephone and then
following your mobile telephone instruction booklet to remove the PIN lock. Your SIM account must be
setup to allow SMS (text) messaging. You can test the SIM in a hand phone to make sure it can send a SMS.
To start with T23 Fleet installation, you must first plan what type of installation you are about to produce.
Below are the options and guides you should refer upon planning.
> Standard Vehicle Installation – refer to T23_Fleet_Installation_Guide.pdf
> Vehicle Installation with Immobilizer – refer to T23_Fleet_Immobilizer_Guide.pdf
> Installation with GPRS connection – refer to T23_Fleet_GPRS_Guide.pdf
The Power light should flash every 5 seconds. The GSM light will be red for a minute and will turn off
when connected to the GSM network. If the light remains red then check the troubleshooting section.
2. Charge your unit for 3 hours
via USB. Use the T23 Fleet USB cable to connect the unit to PC or USB
charger then press the power button (middle button) for 2 seconds. Charging on low battery state will
turn power light on solid yellow then will turn to solid green when enough charge was gained. When fully
charged, the green light will change from solid green to blinking green. If the unit has been in storage it
may take 15 minutes for the power light to turn on.
3. Get GPS lock.
Take the unit outside leave the T23 Fleet there for a couple of minutes and check the
Step 1. Plan
Step 2. Setup
After T23 Fleet has been initially set up, check the full functionality of your T23 Fleet. You communicate
with your T23 Fleet using normal text messages sent to the phone number of the SIM installed in your
T23 Fleet. Follow these steps:
Step 3. Connect
Now your T23 Fleet is ready to use. From your mobile phone try sending the FIND command to your unit
– just send a SMS with the text F in the message – upper or lower case. Turn on trip and power reporting
by sending two SMSs,
TRIP,ON
and
POWER,ON
or shortly combined in one message
T
>
P
to the unit. Your
T23 Fleet will respond with a text message confirming the reporting is turned on.
To allow your friends to find you add their phone numbers using the ADDUSER command. Send
AU,phoneNumber,Friend to add a friend’s mobile number.
Try some of the commands in the summary on the next page and connect with your vehicle!
Step 4. Track
Inserting SIM Card
A. Unscrew back cover and open T23 Fleet.
C. Put back the battery and gently push it downward to lock screw back cover tightly.
B. Pull the SIM card holder lock up a bit, then push forward the SIM card to fit.
TIP: You can use a packaging tape over your SIM card before inserting it to
make it easier to be pulled out in case you need to remove the SIM from the unit.
POWER,ON
– Will tell you when your T23 Fleet bat-
tery is below 20%.
POWER,OFF
–Turns off the monitor.
P,ON
Tramigo: low power, parked, 0.34 km S of Harrison
Plaza, Manila, NCR, RP 13:13 Oct 17
VEHICLEIDLE,time,radius
– Turns VehicleIdle
reporting on or off
VEHICLEIDLE,time,radius
– Sends idle report for
a given interval within a given distance radius after
Ignition was started.
VehicleIdle,ON/OFF/interval,distance radius
When vehicle idle is detected:
Tramigo: Vehicle in idle state, parked, at Bangkok
City Hall, Phranakhon, Bangkok, TH, 15:47 May 29
Quick Start Guide
3
BLUE GPS light – it will turn off when your T23 Fleet knows its
location. If the light remains BLUE then check the trouble-
shooting section.
You can also use the optional external GPS antenna to improve
the signal quality.
This means that you are now the
registered Owner of your T23 Fleet
and it will accept any commands that
you send to it from your phone.
Your Tramigo comes with PC and smartphone softwares that make managing your T23 Fleet units even easier.
Visit
www.tramigo.com
to download the latest versions and find out more about M1 Fleet PC softwares and M1
Move Smartphone softwares.
Note: Sending OWNER is
the same with
OWNER,0000
from previous registrations.
Send
Status
command to check
GSM and GPS signal qualities. If GPS
below 50% in open area, the external
GPS antenna is recommended.
STEP
1
STEP
2
More reference guides:
> Complete info with list of commands and parameters – refer to
T23_Fleet_User_Manual.pdf
> Complete lists of commands only – refer to
T23_Fleet_Commands.pdf
> Info for latest features of T23 Fleet – refer to
T23_Fleet_Features.pdf
STEP
3
OWNER
SEND
T23 Fleet
OWNER
Tramigo: Owner, +5551234567
registered, 09:25 Jan 14
SEND
T23 Fleet
STATUS
Tramigo: Status, GSM: 80%,
GPS: 60%, Battery: 100%,
Reports: Alarm, Trip, Speed
(120), 09:25 Jan 14
SEND
T23 Fleet
