- 7 -
Unscrew the axle insert and screw into the opposite
side of the metal base bracket. Attach the metal
base bracket
to the bottom of the refrigerator. Lift
the refrigerator to an upright position.
With the unit on its side, remove the bottom metal
base bracket
. Then gently place the refrigerator on
opposite side to complete the door reversal.
DOOR REVERSAL INSTRUCTIONS
The rubber gasket should be compressed on all
sides of the door. If the gasket is more compressed
on one side, the metal bracket position should
be adjusted. Once the door position is finalized,
securely tighten the screws.
Reinstall the triangular bracket cover by carefully
threading the bracket cover onto the metal
bracket
and pressing down.
To reattach the door, place the door onto the bottom
axle insert. Place the top
bracket
into the door
and align the metal
bracket
holes over the holes in
the top of the refrigerator cabinet. Tighten the two
screws to hold in place.
Reinstall all plastic
hole insert plugs
. The
reinstallation of the plastic
hole insert plugs
is
important to maintain the seal and integrity of the
insulation.
IMPORTANT:
It is extremely important to wait at least six hours before plugging the refrigerator
into a power outlet. During the door reversal process, the refrigerant and compressor oil
mixed. It is important to allow the refrigerant and compressor oil to separate and settle so the
compressor operates properly. Failure to do so will cause severe mechanical problems, perhaps
even the destruction of the unit’s motor/compressor, and will void the warranty.
7a
7
9
8
10
11
