20
EN
MAINTENANCE
Before performing any kind of maintenance work, turn the engine off and unplug the
equipment.
Ensure that all the screws and nuts are always well tightened by constantly checking if the equipment is ready
for use.
If the power cord is damaged, it should be replaced by the manufacturer, an authorized dealer or a
qualified person to reduce risk of injury.
Instructions for waste disposal
Improper disposal of solid waste can cause serious damage to the environment, including soil and
water contamination. Therefore, solid waste should be separated and discarded properly. Recyclable
waste materials should be recycled.
Blade
To remove the blade and make the required repairs, it is enough to fit the screw or star key into the
fastening screw and turn it counterclockwise [Fig. 29, page 10]. When reattaching the blade, put it back
in the same position it was when it was removed with the Tramontina logo visible to the user when
installing it. The blade is correctly positioned with the curved part facing down.
Whenever there is a stronger impact of the blade with any obstacle, the blade must be
removed and carefully inspected. If required, change for a new one. In case of a strange
noise in the engine, take the lawn mower to a specialized Technical Assistance service.
A worn, unbalanced or blunt blade may cause damage to the engine. Use original Tramontina
blades.
Sharpening the blade
The blade can be sharpened using a file or an emery wheel.
Blade balance
To check the blade balance, pass a rod through the middle hole in order to achieve the smallest possible gap.
Rest the rod ends on two supporting and leveled points: if the blade is imbalanced, the heavier side will slant.
To balance both sides, pass the heavier side on the portion opposed to the cutting edge on a grindstone
or file and recheck the balance [Fig. 30, page 10].
When reassembling the parts, check for their proper position and ensure the blade holes fit the blade
bracket projections [Fig. 31, page 10].
Cleaning
Avoid the lawn accumulation under of the mower. After use, clean the lawn mower with a brush or with
a wet cloth. Never pour water on the lawn mower.
