12
A801X-SVX001-1A-EN
These furnaces have been classified as Fan Assisted
Combustion system CATEGORY I furnaces as required
by ANSI Z21.47 "latest edition". Therefore they do not
require any special provisions for venting other than
what is indicated in these instructions.
W
Wa
arrn
niin
ng
g:: T
Th
he
esse
e ffu
urrn
na
acce
ess a
arre
e n
no
ott a
ap
pp
prro
ov
ve
ed
d o
orr
iin
ntte
en
nd
de
ed
d ffo
orr iin
nsstta
alllla
attiio
on
n iin
n m
ma
an
nu
uffa
accttu
urre
ed
d ((m
mo
ob
biille
e))
h
ho
ou
ussiin
ng
g,, ttrra
aiille
errss,, o
orr rre
eccrre
ea
attiio
on
na
all v
ve
eh
hiicclle
ess..
Locations and Clearances
The location of the Furnace is normally selected by the
architect, the builder, or the installer.
However, before the Furnace is moved into place, be
sure to consider the following requirements:
1. Is the location selected as near the chimney or vent
and as centralized for heat distribution as practical?
2. Do all clearances between the Furnace and
enclosure equal or exceed the minimums stated in
Clearance Table below?
Minimum clearance to combustible materials
3. Is there sufficient space for servicing the Furnace
and other equipment? A minimum of 24 inches
front accessibility to the Furnace must be provided.
Any access door or panel must permit removal of
the largest component.
4. Are there at least 3 inches of clearance between the
Furnace combustion air openings in the front panel
and any closed panel or door provided?
5. Are the ventilation and combustion air openings
large enough and will they remain unobstructed? If
outside air is used, are the openings set 12" above
the highest snow accumulation level?
6. Allow sufficient height in supply plenum above the
Furnace to provide for cooling coil installation, if
the cooling coil is not installed at the time of this
Furnace installation.
7. The Furnace shall be installed so electrical
components are protected from water.
8. A vertical downflow furnace without a coil, must
use BAYBASE205 when installed on combustible
flooring.
9. If the Furnace is installed in a garage, it must be
installed so that the burners, and the ignition
source are located not less than 18 inches above the