Size
(of the cable gland)
External drilling diameter
(for screwing)
Internal drilling diameter
(for sleeve)
M 16
17
19
M 20
21
23
M 25
26
28
M 32
33
35
M 40
41
43
M 50
51
55
M 63
64
71
Table 3:
Drilling diameters for cable glands
Figure 68:
Step drill
3. Insert sleeve (inside
– see
) and screwing (outside
) into the drillings
Figure 69:
Sleeve
Figure 70:
Screwing
Figure 71:
Cable gland
A drilling with the diameter for the corresponding screwing (see
, column 2) is sufficient for
the insertion of cables into a cabinet or a single walled housing. In this case the screw is locked
with the supplied locknut from the inside.
Transport lock
Remove the, on fan-motor base frame of spring isolators mounted transport lock (signed with red
point) according to
below.
1. Remove nuts and bolts of position 1, 2 and 3
2. Remove z-shaped metal sheet (position 4)
3. Again fasten the nut of position 1, including the potential compensation wire
Summary of Contents for CCEB
Page 48: ...Figure 83 Pulling out the filters Figure 84 Pull out tool...
Page 74: ......
