Since the manufacturer has a policy of continuous product and product
data improvement, it reserves the right to change design and specification
without notice.
Trane
6200 Troup Highway
Tyler, TX 75707
STEP 6
- Braze, leak check with nitrogen, vacuum
and recharge per data plate.
STEP 7
- Install new compressor power lead,
LPCO wires, connect crankcase heater wires and
secure any other wires that were moved during the
compressor replacement. Replace run capacitor if
required in parts notes.
Note
: After and prior to start-up of the new com-
pressor, ensure that all piping and wiring are not in
contact with the access panels when reinstalled.
Note:
If discharge line vibration is an issue, order
part numbers CMP01450 & BAR00178 (clamp and
bar)
Note:
If powered reverse rotation is a problem on
single-phase units, order part number RLY03032
(time delay relay).
STEP 5
- Set the new compressor, tighten the
mounting nuts and use the Trane-supplied
tubing connectors to dry-fit the pipes before
brazing. Replace liquid line drier in the outdoor
coil section of the unit.
