background image

SAFETY  HAZARD!

  This  information  is  intended  for  use  by 

individuals  possessing  adequate  backgrounds  of  electrical 
and mechanical experience. Any attempt to repair a central air 
conditioning  product  may  result  in  personal  injury  and/or 
property  damage.  The  manufacturer  or  seller  cannot  be 
responsible for the interpretation of this information, nor can it 
assume any liability in connection with its use.

Important: 

These instructions do not cover all variations in systems 

nor provide for every possible contingency to be met in connection 
with the installation. Should further information be desired or should 
particular problems arise which are not covered sufficiently for the 
purchaser’s  purposes,  the  matter  should  be  referred  to  your 
installing dealer or local distributor.

Important: 

Installation of this unit shall be made in accordance with 

the National Electric Code, NFPA No. 90A and 90B, and any other 
local codes or utilities requirements.

Note: 

The  small  air  handlers  have  been  evaluated  in  accordance 

with the Code of Federal Regulations, Chapter XX, Part 3280 or the 
equivalent. “SUITABLE FOR MOBILE HOME USE.”

WARNING 

WARNING 

WARNING 

WARNING 

WARNING 

WARNING 

HAZARDOUS VOLTAGE!

Disconnect all electrical power, including remote disconnects 
before  installing  or  servicing.  Follow  proper  lockout/tagout 
procedures  to  ensure  the  power  can  not  be  inadvertently 
energized. Failure to disconnect power before servicing could 
result in death or serious injury.

LIVE  ELECTRICAL  COMPONENTS! 

During  installation, 

testing, servicing, and troubleshooting of this product, it may 
be necessary to work with live electrical components. Failure 
to follow all electrical safety precautions when exposed to live 
electrical components could result in death or serious injury.

EXPLOSION HAZARD!

Do not store corrosive or combustible materials, gasoline, or 
other  flammable  vapors  or  liquids  near  the  unit.  Failure  to 
follow  this  warning  could  result  in  property  damage,  serious 
personal injury, or death.

ELECTRICAL HAZARD!

Grounding  Required!  Follow  proper  local  and  state  electrical 
code  on  requirements  for  grounding.  Failure  to  follow  this 
warning  could  result  in  property  damage,  serious  personal 
injury, or death.

HAZARDOUS VAPORS! 

Do not install an air handler with a 

non-ducted  return  in  the  same  closet,  alcove,  or  utility  room 
as  a  fossil  fuel  device.  Hazardous  vapors  can  be  distributed 
throughout the conditioned space and equipment damage can 
result.

Section 2. Safety Information

WARNING

PROPOSITION  65:  This  appliance  contains  fiberglass 
insulation. Respirable particles of fiberglass are known to State 
of California to cause cancer.

All  manufacturer  products  meet  current  federal  OSHA 
Guidelines  for  safety.  California  Proposition  65  warnings  are 
required  for  certain  products,  which  are  not  covered  by  the 
OSHA standards.

California’s Proposition 65 requires warnings for products sold in 
California  that  contain  or  produce  any  of  over  600  listed 
chemicals known to the State of California to cause cancer or 
birth  defects  such  as  fiberglass  insulation,  lead  in  brass,  and 
combustion products from natural vapor.

All  “new  equipment”  shipped  for  sale  in  California  will  have 
labels  stating  that  the  product  contains  and/or  produces 
Proposition  65 chemicals. Although  we have not changed  our 
processes, having the same label on all our products facilitates 
manufacturing and shipping. We cannot always know “when, or 
if” products will be sold in the California market.

You  may  receive  inquiries  from  customers  about  chemicals 
found  in,  or  produced  by,  some  of  our  heating  and 
air-conditioning equipment, or found in natural vapor used with 
some  of  our  products.  Listed  below  are  those  chemicals  and 
substances commonly associated with similar equipment in our 
industry and other manufacturers.

      Glass Wool (Fiberglass) Insulation
      Carbon Monoxide (CO)
      Formaldehyde 
      Benzene

More  details  are  available  at  the  websites  for  OSHA 
(Occupational  Safety  and  Health  Administration),  at 
www.osha.gov and the State of California’s OEHHA (Office of 
Environmental Health Hazard Assessment), at www.oehha.org. 
Consumer  education  is  important  since  the  chemicals  and 
substances  on  the  list  are  found  in  our  daily  lives.  Most 
consumers are aware that products present safety and health 
risks, when improperly used, handled and maintained.

2

Summary of Contents for OXBOX JMM4A0A18S21SAA













Reviews: