Trane Precedent FIADMPR102 Series, Installation Instructions Manual

Installation – FIADMPR102*

ACC-SVN231A-EN

7 

Factory Installed Damper Set-Up

Downflow Configuration

To position damper for downflow operation, complete the 
following steps:

WARNING

Hazardous Voltage!

Failure to disconnect power before servicing could 
result in death or serious injury. 

Disconnect all electric power, including remote 
disconnects before servicing. Follow proper lockout/
tagout procedures to ensure the power can not be 
inadvertently energized. Verify that no power is 
present with a voltmeter.

1. Remove filter access panel.

2. Remove bottom blockoff from its shipping location. 

See 

Figure 4, p. 7

.

Figure 4.

Remove bottom blockoff

3. Remove the bottom three screws from the damper 

panel.

4. Pull the damper assembly out into operating position 

as shown in 

Figure 5, p. 7

.

5. Secure the damper assembly with two screws at the 

bottom of the corner posts.

6. Install bottom blockoff and secure with three screws.

Figure 5.

Damper assembly operating position

Remove screw to 
remove bottom
blockoff from 
shipping location.

Bottom Blockoff 

Screws used to
secure economizer

Bottom Blockoff