Figure 3-2: Setup Menu Chart
3.2.3 NOTES ON THE SETUP MENU
1. There is an
F21
sub-menu present that is for FACTORY USE ONLY!
2. Detailed descriptions of the setup menu parameters can be found in Chapter 4 of this
manual.
3. The User (“A”) menu sub-menus appear when scrolling left or right from the “F” menu.
4. Some selections shown are not available on all models in the series. Likewise,
additional selections may be available on other models in the series. See Chapter 4
for more information.
3.2.4 EXITING THE SETUP MENU – STAINLESS STEEL ENCLOSURE
1.
Power off the indicator.
2.
Move the slide switch on the rear cover back to the left.
3. Power on the indicator. The display will go through a digit check, then settle into Normal
Operating mode. All front panel keys will now return to their normal mode of operation.
3.3
USER (“A”) MENU
3.3.1 ENTERING THE USER MENU
1. Enter the Setup (“F”) menu by following the directions in Section 3.2.1 or 3.2.2.
2.
Use the ZERO directional keys shown in Figure 3-3 to move right or left in the Setup
(“F”) menu until the indicator shows ” A 1”.
3.3.2 NAVIGATING IN THE USER MENU
Use the directional keys shown in Figure 3-3 to move around in the User Menu Chart shown
in Figure 3-4 on the following page.
1.
To move to a new “A” heading, use the ZERO (left) or PRINT (right) key to move right
or left in the User Menu Chart.
2.
To move to the selection level, press the ZERO (down) key once. The current saved
selection is shown.
3.
To view the available selections for the current “A” heading, use the ZERO (left) or
PRINT (right) key to move through the selection field.
4
.
To save/exit a new selection, press the UNIT/SET key .
5.
Repeat Steps 2 through 5 until the User Menu is programmed.
Neptune 4500 Page 3-3
