7.3 General Scale Operation
7.3.1Force gauge
1. Select the desired weighing unit by pressing the
UNITS
key.
2. If necessary, press the
ZERO
key to obtain a weight reading of zero.
3. Place the object to be weighed on the platter and allow the indicator to stabilize. When
the weighing unit default kN, if the item weight exceeds 9d over the system’s weight
capacity, it displays “□□□□□□”. When the weight unit is N/lbf, if the item weight doesn’t
exceed 9d over the system’s weight capacity, but the display value exceed LED’s
maximum digital, it display “□□□□□□”.
4. Read the weight shown on the display.
7.3.2 Zero & Clear
1. In general force gauge mode, the key is
ZERO
function key: Press the
ZERO
key to
obtain a weight reading of zero.
2. In keeping peak value mode, the key is
CLEAR
function key: Press the
CLEAR
key to
clear the peak value which is shown in the display, prepare to the next peak value
keeping operation.
7.3.3 Keeping Peak Value
1. Press the
PEAK
key to enter keeping peak value mode. The item’s weight is from 2%
to 100% of full capacity, the indicator can record the maximum value in real time.
When the weight is less 2% of full capacity, the function is unable.
2. If necessary, press
CLEAR
key to clear the present peak value shown in the display.
3. Press
PEAK
key again, exit the keeping peak value mode.
4. In calibration mode, press
PEAK
key to enter the present channel to set the
parameters.
7.3.4 Channel Change
1. Press
CHANNEL
( ) key to change the present channel circulating. The default
channel is channel 0. When pressing the CHANNEL ( ) key, the system will automatic
delay 2—5 seconds, then enter the next channel. TI-1500B has four absolute channels for
custom using in the different load cell standard sources.
Note: In general operate mode, just using CHANNEL key to change the channels.
It’s different from using in calibration mode.
7.3.5 Print
1. This key is used to print weight information by serial printer and send weight information
out to the PC by serial port.
