LED Master 64 manual
16
LED indicator above it is blinking the CA-8F has been activated.
1. STANDBY button used to activate the CA-8F or interrupt the connection.
Hold it for about 2 seconds, the LED indicator will go out, then the CA-8F has
been activated.
2. MODE button is used to change the mode. Pressing it when the LED indicator
above is lit up but not flashing, means it has entered into the saved chase mode,
pressing the FUNCTION button can change the chase.
3. When pressing the MODE button till the indicator above is lit up and flashing,
means it has entered into the step mode, pressing the FUNCTION button will
change the step and the number of steps will display on the screen.
4. When pressing the MODE button till the indicator above it is off and then press
the FUNCTION button, all the fixtures’ channels will be on 255, for full on/flood.
CA-8F Foot controller
4.17 Update by USB drive
Power off the unit, and then insert the USB drive with the specific program in it. Hold
PROGRAM/REC button, DOWN button and MANUAL/MUSIC/AUTO button simultaneously,
then power on the unit, when all the lights light up, you can then release the button. The LED
display will show ‘USB-LINK’. The program will update automatically, after it has finished the
update, the LED display will show ‘UPDAP OK’. You can restart the unit and the unit has
been updated successfully.
NOTE: Please use memory stick of between 1GB-2GB. The format of the memory disk
should be FAT16 or FAT32 and the memory disk should be clear before starting.
