AI1422E Reader
TransCore Proprietary
7-37
Group 8 commands provide control of reader functions, such as the sense input lines.
82N Select Input Status Change Report Option
Command !82N selects the input lines to be monitored to report any change in input status.
The enabled input lines are monitored for any changes in the logic states. If a change is
detected, the reader generates an input status change message and treats it as a tag ID. If
the auxiliary information option is enabled, the input status field displays the current input
values. The value for N specifies the report options as shown in
Table 7 – 20
.
Table 7 – 20 Input Status Change Report Options
Command
Report Option
820
Disable status change reports (factory default)
821
Report change on input0
822
Report change on input1
823
Report changes on input0 and input1
Reader response:
Done
830 Disable Automatic Periodic RF Status Report (Factory Default)
Command !830 is a default set in the factory to disable the automatic periodic RF status
report.
Reader response:
Done
831 Enable Automatic Periodic RF Status Report
Command !831 enables the automatic periodic RF status report. This function sends out
a periodic RF status report if no other message (a tag read) is sent from the reader for a
period of time. This message is the same message that would be sent in response to the
!
527
Display RF Status command. Enabling this function is helpful in some sites where
there may not be much tag activity, and the user wants an automatic way to
ensure the communication channel with the reader is still intact. With this function enabled,
the host system will get a message from the reader at least every three minutes.
Reader response:
Done
Summary of Contents for 1422E
