7 CONGLOMKB .COM
Please contact
customer.service@conglomkb.com
or
1-877-333-0098
for further assistance .
Installation (continued)
FAUCET AND SPRAYER INSTALLATION
Sprayer and hose
Faucet
Faucet shank
Faucet shank nut
Rubber gasket
Sprayer housing
support
Nut
Before installing, carefully unpack the faucet and ensure no parts
are missing .
1 . Insert the spray housing support through the pre-drilled
hole on the sink corner . Screw the nut onto the threads and
hand tighten .
2 . Run the spray hose down through the spray housing and up
through the centre faucet mounting hole . Connect the spray
hose to the faucet and tighten with a wrench .
3 . Install the new faucet on sink with hot “H” to the left and
cold “C” to the right . From under the sink, thread mounting
nuts and rubber gaskets onto the faucet shanks and tighten
the mounting nuts .
STRAINER INSTALLATION
1 . Apply a ring of sealant to the underside of the strainer
flange .
2 . Insert the strainer body into the sink .
3 . Assemble the rubber gasket, friction washer and locknut
onto the strainer body from under the sink .
4 . Hand tighten the locknut . Do not over tighten locknut as it
may split or deform the body of the strainer .
Basket
Strainer body
Rubber gasket
Friction washer
Locknut
Sealant
